How to make 3D Raised Heat Transfer Silicone Logo

How to make 3D Raised Heat Transfer Silicone Logo?

To make 3D high density Heat Transfer Silicone LOGO need Molding silicone ink, silicone catalyst, silicone pigments.

If need to make 2 colors more then need silicone reducer to liquid silicone ink for color dispensing by dispensing machine.

For one color making need Vacuum Vulcanizing Machine (3D transfer silicone label making machine),cooling machine.

Tips for single color transfer silicone logo making:

1st : Filling bellow mixing moulding silicone ink together into the mould,Silicone ink mixing ratio:

Moulding silicone XG-360W/360W-1 60G
Silicone catalyst XG-360WB/360WB-3 6G 10%
Pigments 1.8-3G 3-5%

2nd: Get the hot melt film on the silicone ink filled mould

3rd. Machine heat press including vacuum , venting and curing together ,this should get special machine with Vacuum function together.

Cure temp : Uper temp 80-90 degree
Bottom temp 130-140 degree
Heat press for about 1 minutes including vacuum and curing.

4th. Cold the mold ,remove scrap material,Shift the stickers on the position paper.

5th. Heat press the stickers on heat press machine by 160-170 degree for 15-30 seconds.

High-Raised-3D-Transfer-Logo-molding-transfer
High-Raised-3D-Transfer-Logo-molding-transfer
High-Raised-3D-Transfer-Logo-molding-transfer

Leave a Comment

Your email address will not be published. Required fields are marked *

Shopping Cart